When welding the terminals of the tactile switch, if a load is applied to the terminals, there may be looseness, deformation, and deterioration of electrical characteristics due to different conditions. Please be careful when using.

When using through-hole printed circuit boards and circuit boards other than those recommended, changes may occur due to thermal stress, so please confirm the welding conditions thoroughly in advance.

When performing two welding operations, please wait until the first welding part has returned to room temperature before proceeding. Continuous heating may cause deformation of the peripheral parts, loosening and detachment of terminals, and a decrease in electrical characteristics.

4. Introduction to micro touch switches, regarding the setting of welding conditions, it is necessary to confirm the actual batch production conditions.

5. The product is designed and manufactured with a DC resistance load as the premise. Please confirm separately when using other loads [inductive loads, capacitive loads].

6. For the installation holes and patterns of printed circuit boards, please refer to the recommended dimensions recorded in the product drawing.

7. The switch should be used in a structure where it is directly operated by a person. Please do not use it for mechanical testing functions.

When operating the light touch switch, if a load above the specified level is applied, there is a possibility of damage to the switch. Please be careful not to apply force above the specified level on the switch.

9. Please avoid using the operating part from the side.

10. Analysis of micro touch switches: For flat shaft type switches, try to press the center of the switch as much as possible. For the hinge structure, when pressed, the position of the shaft will move, please pay special attention.